Frigidaire Ice Maker Will Not Dump Ice

I just replaced the icemaker with a new one.

Frigidaire ice maker will not dump ice. I can initiate the dump sequence and it will process the ice out but it will not do it. We have had the water valve replaced and the air humidifier replace and the ice maker unit. If none of these parts are at fault and the freezer. Certain ice dispensers built into the freezer compartment of your refrigerator offer the option of crushed or cubed ice.

The water despenser works great and water is getting to the icemaker too. This heating element may be burnt out. Use a multimeter and check the ice maker mold thermostat ice maker mold heater and the ice maker module for faults to see if this is causing the ice cubes to not drop. O normally open and when cold from the ice in the mold it will close which tells the motor to dump the ice.

There is usually an arm attached to the ice maker that raises as the ice fill the bucket below. This thermostat is n. The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft. My icemaker will not dump the ice.

If you ve chosen cubes but get crushed ice instead there s no need to. The gear box turns very slowly but has lots of power to push the ice. I have a frigidaire refigerator that is 8 years old and the ice maker is not working. If this arm is in the raised position it will not make or dump additional ice.

It fills the trays but read more. Some ice makers heat a little so they can release the ice to dump. Since many of the ice maker components are not sold separately you may need to purchase and replace the entire ice maker assembly. It is getting the water and it freezes but will not dump the ice.

Refrigerator parts available on amazon ice makers check the ice maker parts with a multimeter. Before replacing the ice maker assembly check the water inlet valve water line and fan. One component of the ice maker assembly might be defective.